| www.RiversideRenegades.com http://riversiderenegades.com/forums/ |
|
| hammer time? http://riversiderenegades.com/forums/viewtopic.php?f=5&t=236 |
Page 1 of 1 |
| Author: | crustycheese [ Sat Sep 25, 2004 9:32 pm ] |
| Post subject: | hammer time? |
i was playin at riverside 2 weeks ago and it was a great day....until i cleaned my gun later. i looked at my hammer and there was a little chuck taken out of it!  is this sumthing 2 be overly concerned about? if i need a new hammer where can i get a good one cheap...or how much would it be?
any help would be greatly appreciated  THANKS!!
|
|
| Author: | Azzy [ Sun Sep 26, 2004 12:46 am ] |
| Post subject: | |
There should be a flat spot on the bottom.. if thats what you are talking about. Otherwise, a small bit shouldn't hurt, as long as it doesn't drag on metal, interfere with the sear, or take too much mass from the hammer, it should be fine. |
|
| Author: | kzuroski [ Sun Sep 26, 2004 9:30 am ] |
| Post subject: | |
Azzy's the expert, and I'm not sure what the "hammer" is, but I do know that paintball guns can experience a considerable amount of wear and still work just fine--in fact, in some places like the bolt, one expects wear. |
|
| Author: | Azzy [ Sun Sep 26, 2004 8:18 pm ] |
| Post subject: | |
hammer = striker |
|
| Author: | prince valiant [ Mon Sep 27, 2004 8:25 pm ] |
| Post subject: | |
d#@m azzy i teach you what i know and you get labeled the "expert", matt was the original, not sure what you would call me |
|
| Author: | jamesmbaldwin [ Thu Oct 07, 2004 8:59 am ] |
| Post subject: | |
it was probally from hitting against the ball detent? of course that would be the bolt |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|