| www.RiversideRenegades.com http://riversiderenegades.com/forums/ |
|
| Paint Size? http://riversiderenegades.com/forums/viewtopic.php?f=5&t=416 |
Page 1 of 1 |
| Author: | myfault [ Tue May 03, 2005 3:58 pm ] |
| Post subject: | Paint Size? |
I know we use big ball paint and i was wondering if any one knew the exact bore size. |
|
| Author: | Fets [ Tue May 03, 2005 4:25 pm ] |
| Post subject: | |
.689-.691 |
|
| Author: | Azzy [ Tue May 03, 2005 9:46 pm ] |
| Post subject: | |
There is a relative size to most paints... and I have found most cases of big ball to be on the small size, requiring me to use my medium or smaller barrels. |
|
| Author: | jamesmbaldwin [ Wed May 04, 2005 3:58 am ] |
| Post subject: | |
No way the big ball at river side is .689-.691, it rolled out of a .685 cocker insert when I played. And the big ball I buy rolls out a .684 micro shot. |
|
| Author: | Fets [ Wed May 04, 2005 10:44 am ] |
| Post subject: | |
Well I got those numbers from Ottersscustoms.com, take it up with him. |
|
| Author: | myfault [ Fri May 06, 2005 1:32 pm ] |
| Post subject: | |
ok i have a freak barrel and i dont know what insert to use ideas? lol |
|
| Author: | Azzy [ Sat May 07, 2005 6:22 am ] |
| Post subject: | |
use it the way it was designed, fit the paint to your insersts. take a few balls from the batch, check them out. Paint size will differ with temp and humidity, as will the size of your inserts will with temp changes. |
|
| Author: | crustycheese [ Sat May 07, 2005 9:00 am ] |
| Post subject: | |
i have a freak kit as well and i have used every insert atleast once. so when fitting your paint try and get the ball into as tight a insert as you can without the ball getting stuck, it should rest in the insert tighty and be easilly blown out, if your face turns purple trying to blow it out then its too small. |
|
| Author: | mitshu04 [ Sat May 07, 2005 4:45 pm ] |
| Post subject: | |
crustycheese wrote: i have a freak kit as well and i have used every insert atleast once. so when fitting your paint try and get the ball into as tight a insert as you can without the ball getting stuck, it should rest in the insert tighty and be easilly blown out, if your face turns purple trying to blow it out then its too small.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|