www.RiversideRenegades.com

Here it is, Smart Parts Boss #185. bought from the original owner, he received it with a siphon tank, (sherader valve) which was factory marked with nail polish or paint at the valve seam (a bit early on this, ne?)



The grip frame (that front rod is threaded)



The internals.. The infamous cup seal setup, where the valve retainer is made of derlin (or similar material), and the seal / ball end makes the seal against it.



The barrel threading is close to cocker on this end...



But on this end (under the muzzle brake) it is cocker...





From way back when SP was just drilling porting on unibody phantoms and the like... back before the PVI Shocker and the SmartMag... 1 of 500, hard to find, and an interesting gun. Emailed SP about it, wonder if I can get any info.. (they didnt have any on the PVI I have...)

_________________
Later,
Bryan "Azzy" Spiegel
www.riversiderenegades.com
[url:3eidvjl2]http://www.PaintBallCity.org[/url:3eidvjl2]

That muzzle break is sweet.

Looks good Azzy, can't wait to see it.

Out,

J.T.

Nice gun.

_________________
SwAGGeR at One Zero Zero and climbing.

nice, is that a slider trigger?

_________________
www.paintballreenactors.com combining paintball with history

I wish.. Looks a lot like a wintec slider, but is a pretty sloppy 007 style setup.

Might look at shimming it to get the side to side play out. Havent played with it much to see if it autotriggers either (not that I would want to on this gun.. that power tube goes, Im screwed.)

_________________
Later,
Bryan "Azzy" Spiegel
www.riversiderenegades.com
[url:3eidvjl2]http://www.PaintBallCity.org[/url:3eidvjl2]

looked sort of like the trigger on an outlaw (2?)

_________________
www.paintballreenactors.com combining paintball with history